Front electrics.

I'm going to use a fairing that came with the parts I bought, unfortunately it didn't include the bracket and rubber bag that is used to put the the loom joins in. Normally they go in the headlight bucket but with the fairing the headlight sits further forward and the wires don't stretch that far. I made a plate from aluminium with 2 folds back over the fork stanchions.
The plate was drilled and tapped with cable tie bases screwed on which lined up with the various incoming looms.

The picture below shows a stainless square tube cut at an angle and drilled and tapped to hold the front plate on.

Front shot of the plate with all the cables connected.

Velcro was put on the sides and back of the aluminium plate which holds a sheet of vinyl over the top and around the sides of the plate.